Hose Tail – SAE Swivel Female – 90° Swept – Two-Piece Crimp-On

An SAE 45° flare swivel female on a 90° swept crimp tail, for refrigeration, LPG, fuel and older automotive lines.

Mild steel body with a plated finish, manufactured to the standard listed above.

Two-piece crimp-on – how it goes together

This is the tail (stem) only. A two-piece assembly is the tail plus a separate ferrule crimped over the hose. Our FS‑R2 Multi‑Fit ferrule covers 1‑wire, 2‑wire, M3K and MXT braided hose, so one ferrule series does the lot and you stock half the parts.

🔗 Add the matching FS-R2 Multi-Fit ferrule

Watch: How to Identify Hydraulic Hose Fittings and Hydraulic Adaptors JIC and BSP

Thread Standards

• SAE 45° Flare Female – SAE J512 45° flare, seals on the mating 45° cone and must not be paired with a JIC 37° fitting

How to Choose

• The bend is formed into the tail, so the angle is fixed. Decide which way the hose has to leave the port before you order – you cannot rotate it after it is crimped.
• A 45° flare and a 37° JIC look near enough identical. Nose the cones together to tell them apart.
• The flare seals, not the thread.

Technicians Advice

The 45° seat is shallow and soft. Wind it to a firm feel and stop – once bruised it never seals properly again and the fitting is scrap.

Where You’ll Find It

• SAE 45° Flare Female – Female side of 45° flare lines on refrigeration and light automotive work.

Cross-Reference

• SAE 45° Flare Female – SAE J512 45° flare.

Parker, Gates, Aeroquip and Ryco all manufacture to these same standards under their own part numbering, so a fitting built to the standard above will mate with theirs.

Cross-references are given at series level as a guide to the standard, not as a part-for-part substitution. Always confirm the thread form, size and seal type against the port before ordering.

Downloads

📄 Crimp Dimensions Chart (PDF) 📄 Thread Identification Chart (PDF)

Same Threads, Other Angles

🔗 Straight – same threads

Express shipping Australia-wide. We dispatch daily to New South Wales, Victoria, Queensland, Western Australia, South Australia, Tasmania, the Australian Capital Territory and the Northern Territory – Sydney, Melbourne, Brisbane, Perth, Adelaide, Hobart, Canberra and Darwin, plus regional and remote sites.

Ayrtec two-piece crimp-on hose tails, stocked and dispatched by Hydraulic.Online.

Need a hand? Call 1300 146 737 or email sales@mhfgc.com.au – real technicians, real answers.