Hose Tail – SAE Male – Straight – Two-Piece Crimp-On

An SAE 45° flare male on a straight crimp tail, for landing a hose into a 45° flare female.

Mild steel body with a plated finish, manufactured to the standard listed above.

This is the tail only – ferrules are sold separately

A two-piece crimp-on assembly is two separate parts: this tail (the stem) and a ferrule that crimps over the hose. The ferrule is not included. You need one ferrule per tail.

We sell them separately on purpose. Several different ferrule styles will fit, and the right one depends on the hose you are crimping onto, not just the size:

• FS‑R2 Multi‑Fit – 1‑wire, 2‑wire, M3K and MXT braided hose. One series covers the lot, so most jobs take this.
• FS‑R7 – thermoplastic 100R7 hose. Different outside diameter and crimp figure to braided hose.
• FS‑R14 – PTFE 100R14 hose with stainless braid.

🔗 Choose your ferrule – see all styles

Not sure which one? Tell us the hose you are using on 1300 146 737 and we will match it. Never mix a tail from one system with a ferrule from another – the crimp diameter will be wrong.

Watch: How to Identify Hydraulic Hose Fittings and Hydraulic Adaptors JIC and BSP

Thread Standards

• SAE 45° Flare Male – SAE J512 45° flare, seals metal-to-metal on the 45° cone, which is shallower than a JIC 37°

How to Choose

• A straight tail is the default. Only go to a bend when the hose would otherwise leave the port at an angle it does not like.
• Confirm the flare is 45° and not 37° before you commit.
• The flare seals, so nothing goes on the thread.

Technicians Advice

A 45° male pulled into a 37° female will hold pressure for a while then fret the seat and fail. Check the angle at the bench, not on the machine.

Where You’ll Find It

• SAE 45° Flare Male – Refrigeration, LPG and some light automotive and agricultural lines.

Cross-Reference

• SAE 45° Flare Male – SAE J512 45° flare. Shallower cone than JIC 37° and must not be mixed with it.

Parker, Gates, Aeroquip and Ryco all manufacture to these same standards under their own part numbering, so a fitting built to the standard above will mate with theirs.

Cross-references are given at series level as a guide to the standard, not as a part-for-part substitution. Always confirm the thread form, size and seal type against the port before ordering.

Downloads

📄 Crimp Dimensions Chart (PDF) 📄 Thread Identification Chart (PDF)

Express shipping Australia-wide. We dispatch daily to New South Wales, Victoria, Queensland, Western Australia, South Australia, Tasmania, the Australian Capital Territory and the Northern Territory – Sydney, Melbourne, Brisbane, Perth, Adelaide, Hobart, Canberra and Darwin, plus regional and remote sites.

Ayrtec two-piece crimp-on hose tails, stocked and dispatched by Hydraulic.Online.

Need a hand? Call 1300 146 737 or email sales@mhfgc.com.au – real technicians, real answers.