Variable High Flow Lance Assembly

One pressure, one nozzle, no moving parts to go wrong. Single lances are what most operators actually want - a straight or bent tube with a decent grip that puts the nozzle where the dirt is. This listing runs from bare lance tubing you bend and fit yourself, through moulded and insulated grip lances, to complete gun and lance assemblies and variable high flow wands. All current stock.

Ways to buy this lance:

Choose your size

What is in the box

• One lance, wand or length of lance tubing as selected
• Grip fitted where the model describes one
• Complete gun and lance assemblies include the gun
• Nozzles are NOT included unless the description says so

Technicians Advice

The bit nobody tells you about lances: the tube is a wear item and it wears from the inside out. Grit that gets past the inlet filter scours the bore, and on a zinc plated tube the plating goes first, then the steel starts shedding into the nozzle. If you are chewing nozzles faster than usual and the water looks fine, cut an old lance in half and look at the bore - that is usually where it is coming from. Second, do not over-tighten the nozzle. These are tapered threads into a thin wall tube and a nozzle wound in with a shifter will split the end, sometimes weeks later. Nip it and check for a weep. Third, if you are bending your own tubing, use the bender - heating and bending by hand thins the outside of the bend and that is exactly where it will burst, at head height, next to the operator.

Complete your setup

Browse Trigger GunsBrowse Dual and Hi-Lo LancesNozzles and Nozzle Holders

Buying in bulk or fitting out a fleet? Call us for trade pricing.

Need help choosing? Call 1300 146 737 or email sales@mhfgc.com.au – real technicians, real answers.