Taipan Ball Quick Release Couplers – ISO 7241-A (DNP PDS1)

The PDS1 ball-lock coupler is Taipan's answer to hard, high-frequency connection work on agricultural remotes and mobile plant. Made in Italy by DNP, the ball-locking sleeve takes daily coupling abuse without brinelling, and the push-pull versions connect one-handed against residual pressure.

Use the dropdowns to choose your size, then pick a male half, female half, or a pair (1 male + 1 female).

Interchange: ISO 7241-A — connects with DNP PDS1, Faster ANV, Stucchi A-series, Parker 6600, Aeroquip 5600 and other A-pattern couplers.

• plated finish carbon steel body, hardened contact areas
• Ball-locking sleeve for high-cycle duty
• Push-pull female versions connect under residual pressure
• Nitrile seals, PTFE back-up rings

Sizes & Part Numbers

Ratings are the coupled figures from the official Taipan 2024 catalogue - see the datasheets below for full dimensions, flow and interchange charts.

Technicians Advice

Ball couplers wear at the locking balls first - if a sleeve starts feeling gritty, replace the pair before it lets go under load. Always depressurise before disconnecting standard versions; only the push-pull females are designed to work against residual pressure.

Official Taipan Datasheets

📄 Ball Coupler Spec Sheet 📄 Full Coupler Catalogue

Buy in bulk and save: 5+ units −5%, 10+ −10%, 25+ −12.5%, 50+ −15% — applied automatically in the cart.

Need a size or thread you can't see here? Call us on 1300 146 737 or email sales@mhfgc.com.au - if Taipan or DNP make it, we can get it.

Express shipping Australia-wide. We dispatch daily to New South Wales, Victoria, Queensland, Western Australia, South Australia, Tasmania, the Australian Capital Territory and the Northern Territory – Sydney, Melbourne, Brisbane, Perth, Adelaide, Hobart, Canberra and Darwin, plus regional and remote sites.