
PTO Alternative for Trucks, uses a 4 kW 24 Volt DC Hydraulic Power Unit, Flows up to 12.9 Lt/min at 100 bar (1,500 psi) and 7.5 Lt/min at 210 bar (3,000 psi)
This is a High Power Unit with Pressure discharge and Tank Suction Ports directly connected to the pump.
Please note this Unit does not have a built in relief Valve but is available as an optional extra.
Used this 24 Volt DC Power unit is an alternative to a mechanical PTO pump. It has a high-output 24 V DC 4.0 kW Fan Cooled motor and is supplied with a 4.2cc pump, (these may be upsized or Down sized for no, or little extra cost, please see below.
Note: It does not come with an oil tank or a built in relief Valve.
We do have a unit with a tank as well. It is a pressure & suction setup from the pump. This unit can only be used intermittently, see the duty cycle below.
This unit will flow more oil up to 12.9 Lt/min at 100 bar: (1,500 psi) and has the capacity to produce up to 210 Bar of pressure (but at reduced 7.5 Lt/min oil flow), but keep in mind this unit draws high amperage between 140 and 2230 amps so large cross section cables must be used and High-quality batteries are required. It is ideal for cranes (you can hook up your valve micro switch auto start as per the diagram) or Medium-tipper trucks.
Some very large tipper trucks hoist rams can require 40-50 liters of oil to extend. This will be pushing the 'duty cycle' time, potentially causing the auto heat cut-out switch.
Not recommended for very large hoist rams.
Capable of generating up to 200 Bar (3000 PSI) Pressure.
Can be mounted Horizontally or Vertically (Motor Up)
This is a quality motor and pump Manufactured to very high standards.
Please watch the Video below to learn more about our DC power units
Please call or email us for this freight option
contact us on (07) 5563 1982.
Or email us at
sales @mhfgc.com.au
MM 06/06/2025 abc $ SEO option