Modular Cetop Pressure Switch Manifold Blocks – NG6 and NG10

A sandwich block that drops into a Cetop valve stack and gives you a port to mount a pressure switch on. Instead of tapping into a line somewhere and running extra plumbing, the switch bolts to the stack and senses A, B or P directly. Rated to 350 bar.

Pick your block

Specifications

How to choose

• Match the block to the Cetop pattern of the stack it is going into – NG6 blocks do not fit NG10 stacks.
• Decide which port you are sensing before you order: A and B for load-holding or clamp confirmation, P for supply pressure.
• The block gives you the port; the switch is bought separately – F4, K5 or a digital unit all suit.
• Remember the block adds height to the stack, so check your tie-bolt length.

Technicians Advice

Check your tie-bolt length before you order: every module you add to a Cetop stack needs longer bolts, and a block torqued down on bolts that are one thread short will weep at the seals and eventually blow a gasket out sideways. Fit new seals rather than reusing the old ones – they cost almost nothing and a stack that has to come apart twice costs a morning. Sensing P gives you supply pressure regardless of what the spool is doing, which is what you want for pump and accumulator control; sensing A or B tells you what the actuator is actually seeing, which is what you want for clamp and load-holding confirmation. Torque the tie bolts evenly in a cross pattern to the valve maker’s figure – overtightening distorts the block faces and causes the very leak you were trying to prevent.

Specifications and datasheet

Download the Pressure Switches, Transducers and Digital Displays spec sheet (PDF)

Complete your setup

F4 Series Pressure SwitchesK5 Series Pressure SwitchesDigital Pressure Switches

Need help choosing? Call 1300 146 737 or email sales@mhfgc.com.au – real technicians, real answers.