Lenflex SAE 100R2 two wire braid Pressure Washer Hose - 3/8" - 6,000 psi

Smooth grey cover, two wire, in the long lengths. Nothing on the outside to snag as it feeds on and off a reel, and it wipes down at the end of the day instead of holding grime in a textured surface.

Choose from the dropdown above. Every length is made up and ready to fit: 3/8" female swivel x 3/8" BSP male.

Ways to buy this hose

• Off the shelf – all 2 lengths below are made up, tested and ready to dispatch
• Every one carries its own part number, so a reorder gets you exactly the same hose
• The cover colours are the same hose inside. The difference is what you are dragging it across
• Want a length we do not list, a different fitting on the end, or both? We make them up here – call us
• Need something to wind it onto? See our hose reels

Lengths and Part Numbers

What is in the box

• One 3/8" sae 100r2 two wire braid hose assembly, cut and swaged to the length you choose
• Ends: 3/8" female swivel x 3/8" BSP male, fitted both ends
• Pressure tested and capped before it leaves the bench
• Hose only – no reel, gun or nozzle unless the option you pick says otherwise

Specifications

How to choose

• Measure the run, then add ten to fifteen per cent. A hose pulled tight is a hose that gets dragged over an edge
• Check the machine, not the hose. This one tops out at 6,000 psi (414 bar), and your pump wants to sit comfortably under that rather than right on it
• Running hot water? Rated to 155°C
• Cover is a job decision, not a pressure one. Non-marking colours for finished floors and paintwork, dark covers for yards, gravel and anything abrasive
• Not sure the ends suit your machine? Send us a photo of the fitting and we will tell you straight

Technicians Advice

• Rate the hose to the unloader, not the plate on the machine. An unloader dumping to bypass spikes above the machine's rated pressure. This hose is good for 6,000 psi continuous.
• Most hoses die at the ferrule. The failure is a fold 50 mm behind the fitting from dragging the hose round a corner. Bend restrictors on both ends are the cheapest life extension going.
• Never clamp-repair a burst hose. Once the reinforcement lets go the length is scrap - a barb and clamp on 6,000 psi water is a real injection-injury risk.
• Long runs cost pressure. Roughly 5% loss per 15 m at full flow. Soft at the gun on a long run means step up a bore, not wind up the unloader.
• UV kills covers. Stored on a reel out of the sun, a hose lasts about twice as long as one living in an open ute tray.

Complete your setup

Waterblast Ultra High Pressure Water BlastinSemperit Semperjet R2 Two Wire Pressure WashSemperit R1 One Wire Pressure Washer Hose 3/Browse all 3/8" Pressure Washer HoseHose Reels

Buying in bulk or fitting out a fleet? Call us and we will price the job.

Not sure what suits your machine? Call us on 1300 146 737.