Lenflex R2 two wire braid Pressure Washer Hose - 1/4" - 5,800 psi - Grey non-marking

Same light 1/4" two wire hose, but fitted with 3/8" ends so it plugs straight into a standard machine outlet and gun without adaptors. This is the one most people actually want.

Pick your length from the dropdown above. Every length is made up and ready to fit: 3/8" female swivel x 3/8" BSP male.

Ways to buy this hose

• Off the shelf – all 6 lengths below are made up, tested and ready to dispatch
• Every one carries its own part number, so a reorder gets you exactly the same hose
• The cover colours are the same hose inside. The difference is what you are dragging it across
• Want a length we do not list, a different fitting on the end, or both? We make them up here – call us
• Need something to wind it onto? See our hose reels

Lengths and Part Numbers

What is in the box

• One 1/4" sae 100r2 two wire braid hose assembly, cut and swaged to the length you choose
• Ends: 3/8" female swivel x 3/8" BSP male, fitted both ends
• Pressure tested and capped before it leaves the bench
• Hose only – no reel, gun or nozzle unless the option you pick says otherwise

Specifications

How to choose

• Measure the run, then add ten to fifteen per cent. A hose pulled tight is a hose that gets dragged over an edge
• Check the machine, not the hose. This one tops out at 5,800 psi (400 bar), and your pump wants to sit comfortably under that rather than right on it
• Running hot water? Rated to 155°C
• Cover is a job decision, not a pressure one. Non-marking colours for finished floors and paintwork, dark covers for yards, gravel and anything abrasive
• Not sure the ends suit your machine? Send us a photo of the fitting and we will tell you straight

Technicians Advice

• Rate the hose to the unloader, not the plate on the machine. An unloader dumping to bypass can spike well above the machine's rated pressure. This hose is good for 5,800 psi continuous - check what your unloader actually does before you go smaller.
• Most hoses die at the ferrule, not in the middle. The failure is almost always a fold 50 mm behind the fitting from dragging the hose round a corner. Bend restrictors on both ends are the cheapest life extension you can buy.
• Do not coil tighter than about 120 mm radius. Tight winding work-hardens the wire braid. Use the reel, not your elbow.
• Swivel on the gun, male on the machine. That is what stops the hose corkscrewing as you work around the job.
• Never clamp-repair a burst wire hose. Once the braid lets go the length is scrap. A barb and clamp on 5,800 psi water is a genuine injection-injury risk.
• Long runs cost you pressure. Budget roughly 5% loss per 15 m at full flow. If the gun feels soft at 60 m, that is the hose, not the pump - step up a bore rather than winding the unloader.
• UV is what kills the cover. Store it on a reel out of the sun and you will get roughly double the life of one that lives in an open ute tray.

Complete your setup

Thermoplastic Pressure Washer Hose 1/4"Lenflex R2 Two Wire Pressure Washer Hose 1/4BARflex Spiral Wrap Two Wire Pressure WasherBrowse all 1/4" and 5/16" Washer HoseHose Reels

Buying in bulk or fitting out a fleet? Call us and we will price the job.

Not sure which length or which cover suits your machine? Call us on 1300 146 737.