Genuine Gates PRO Series CR2 two-wire braid hose assemblies, made to your exact end-to-end measurement in 6.4 mm (1/4") through 25.4 mm (1") bore, up to 20 metres long. Rated 2,400 psi at 25.4 mm (1") right up to 5,800 psi at 6.4 mm (1/4").

This is the hose that does the heavy lifting - pump pressure lines, ram and cylinder circuits, tippers, log splitters, excavator and tractor implement work. It is what most machine circuits are plumbed in, and the size we sell most of.

Every assembly is built with two-piece crimped hose tails in the thread of your choice on each end, pressure-tested, capped and tagged. Pick your bore below.

Two things worth knowing before you order

Everything here is sized in millimetres - bore, bend radius and end-to-end length - with the imperial size in brackets, because that is how gear gets measured in Australia. And every assembly is built with one angled end at most. A hose bends in one plane and will not be twisted, so two fixed elbows can never be lined up properly without the machine in front of us. Put your elbow on End 1, then screw a 90° or 45° adaptor onto the straight end - it rotates on its thread, so you set the angle on the machine and can change it later.

⭐ Free Thread Identification Chart - print and measure