Genuine Gates PRO Series CR1 one-wire braid hose assemblies, made to your exact end-to-end measurement in 6.4 mm (1/4") through 25.4 mm (1") bore, up to 20 metres long. Rated 1,250 to 3,275 psi depending on bore.

CR1 is the everyday hose - return lines, case drains, low-flex accessory and auxiliary lines on tractors, trucks, farm gear and workshop power packs. If the line sees real pump pressure, step up to the CR2 two-wire range instead.

Every assembly is built with two-piece crimped hose tails in the thread of your choice on each end, pressure-tested, capped and tagged before it ships. Pick your bore below.

Two things worth knowing before you order

Everything here is sized in millimetres - bore, bend radius and end-to-end length - with the imperial size in brackets, because that is how gear gets measured in Australia. And every assembly is built with one angled end at most. A hose bends in one plane and will not be twisted, so two fixed elbows can never be lined up properly without the machine in front of us. Put your elbow on End 1, then screw a 90° or 45° adaptor onto the straight end - it rotates on its thread, so you set the angle on the machine and can change it later.

⭐ Free Thread Identification Chart - print and measure